Skip to content
A rusted gate valve on old pipework

Fixtures

Faucet repair in Milton

A dripping tap is almost never the whole faucet; it is a cartridge, a washer or an O-ring that has worn out. Swap that part and the faucet is good for years.

  • Suits: Dripping and stiff taps
  • Typical visit: About an hour
  • Fault shown to you before any repair
  • Firm price on site, then the work
  • Drop sheets down, mess cleaned up after
Call now ยท (365) 364-2776

A person answers. No forms, no apps.

A rusted gate valve on old pipework.

Inside the faucet

Single-lever faucets use a cartridge that mixes hot and cold; when its seals wear, the tap drips or the handle gets stiff. Older two-handle taps use rubber washers that compress against a seat. Kitchen faucets with pull-down sprayers also have hoses and quick-connects under the sink that can leak into the cabinet.

Signs this is the job you need

  • Spout that never quite stops dripping
  • A wet ring on the counter around the tap base
  • Handle stiff or grinding when turned
  • Hot and cold not mixing properly
  • Damp cabinet floor under the sink

Talk it through with a plumber

One call to (365) 364-2776 reaches someone who can tell you what the job involves and when a van can be at the door.

Call now

How the work goes

  1. We turn off the shut-offs under the sink.
  2. We strip the tap down to find what has worn.
  3. We clean scale from the body and seats.
  4. We fit the new cartridge or washers.
  5. We test for drips at the spout and below.

The repair

Stops closed under the basin, the handle comes off, remove the retaining clip or nut and pull the cartridge. We match it to a new one, clean any scale from the body and reassemble with fresh O-rings and silicone grease.

  • Under the sink we check the supply lines and the sprayer hose for wear.
  • If the faucet body itself is cracked or the parts are no longer made, we tell you replacement is the better route.

Asked on the phone line

Can every faucet be repaired?

Most quality faucets can. Some cheaper models are not worth fixing because parts are not available.

My under-sink shut-off will not close. Now what?

We can replace it as part of the repair.

How a call to us runs

  1. You ring (365) 364-2776 and a person picks up, not a menu.
  2. We ask where the water is, what you have already shut off and what decade the building went up in.
  3. We say when the van should pull up and what to do until it does.
  4. On site we show you the fault, give a firm price before starting and clean up after.

Phone booking keeps things quick: no forms, no portals, no follow-up emails trying to sell you a maintenance plan.

Related pages

Homes · shops · condo buildings

Water where it shouldn’t be? Ring now.

Call (365) 364-2776
Call now · (365) 364-2776